SYMBOLSINK CO., LIMITED

High quality products, professional services, has become the core supplier of ceramic sanitary ware industry!

Tel: 86-13696919243  E-mail:sale@symbolsink.com
Home > News > Content

Installing A Bathroom Vessel Sink

- Jun 18, 2017 -

How to properly install the bathroom vessel sink. The bathroom vessel sink is not a big project in the installation, but does not mean that it does not need to be carefully installed, if the method is not correct will cause future life trouble. This article on this topic for everyone to make an introduction, take you to understand how to properly install the bathroom vessel sink.

1. Leave the position. Each family chooses the trough style to have the difference, therefore the table to leave the bathroom vessel sink position should and the bathroom vessel sink volume match, in the order table should inform the table supplier trough the approximate size, lest meets the rework question.

2. The faucet and the inlet pipe should be installed before installing the bathroom vessel sink. Installation of the faucet, not only requires a strong installation, and the junction can not appear seepage.

3. Put the bathroom vessel sink, will bathroom vessel sink some of the function accessories are installed, you can put the bathroom vessel sink to the table in the corresponding position, ready to start the next step of the installation program.

4. Start installation, the installation of faucet, will be installed in the faucet in advance connected to the inlet of the water switch, the installation should pay attention to the cohesion of the firm, but also pay attention to a detail, that is, the location of hot and cold water pipe, do not make the wrong. Install overflow hole of the sewer pipe, overflow hole is to avoid the water tank to overflow the protection of the hole, so in the installation of water pipes in the overflow hole, to pay attention to the sealing with the groove body, to ensure that the overflow hole of the water pipe itself does not leak. Installation of the filter basket of the sewer, filter basket under the water pipe in the installation, the main attention to the connection between the pipe and groove, not only to be firm, but also to seal. Installation of a whole drainage pipe, usually people will buy a two filter basket bathroom vessel sink, but two of the distance between the water pipes, workers in the installation, will be based on the actual situation of the drainage pipe to cut, at this time to pay attention to the sealing between each interface, the common leakage problem occurs in these joints. Installation of hanging piece reinforcement groove body, bathroom vessel sink into the table, need to be in the trough body and the table to install matching hanging piece, the bathroom vessel sink will be installed firmly, to avoid small voids caused by the groove sway.

5. Installation closure, the drainage test, after the basic installation, the filter basket is also installed, to begin the next experiment. When doing the drainage test, the bathroom vessel sink should be filled with water and the drainage of two filter baskets and overflow holes are tested. Drainage, if found where there is water seepage phenomenon, should be immediately rework, to ensure that the future use is not hindered. Sealing edge around the groove, after the drainage test, to ensure that there is no problem in the case, the bathroom vessel sink can be closed. In the use of silicone sealing edge, to ensure that the bathroom vessel sink and mesa connection gap evenly, can not have water seepage phenomenon.

6. Completion of the bathroom vessel sink installation, the completion of the edge, the installation of the tank will be successfully completed. The bathroom vessel sink is small, but because of its frequent use, the connection installation at each sewer is critical.