SYMBOLSINK CO., LIMITED

High quality products, professional services, has become the core supplier of ceramic sanitary ware industry!

Tel: 86-13696919243  E-mail:sale@symbolsink.com
Home > Sink Guide > Content

Bathroom Vessel Sink Plumbing

- Jun 16, 2017 -

Each family chooses the bathroom vessel sink style to have the difference, therefore the mesa leaves the bathroom vessel sink position should and the flume volume match, in the order table should inform the table supplier trough the approximate size, lest meets the rework question.

1. Faucet and bathroom vessel sink plumbing should be installed before faucet installation. Installation of the faucet, not only requires a strong installation, and the junction can not appear seepage. After installing some of the functional parts of the bathroom vessel sink, you can place the sink in the appropriate position on the countertop and prepare to start the next installation. Will be installed in the faucet in advance connected to the inlet of the water switch, installation should pay attention to the cohesion of the firm, but also pay attention to a detail, that is, the location of hot and cold water pipe, do not make a mistake.

2. Installation of overflow hole in the water pipe overflow hole is to avoid the water tank to overflow the protection of the hole, so in the installation of water pipes in the overflow hole, should pay attention to the sealing with the groove body, to ensure that the overflow hole of the water pipe itself does not leak.

3. When installing the sewer pipe under the filter basket, the main attention is attached to the connection between the water pipe and the groove body, not only to be firm, but also to be sealed.

4. Installation of the overall bathroom vessel sink plumbing usually people will buy a sink with two filter baskets, but two of the distance between the water pipes, workers in the installation, will be based on the actual situation of the drainage pipe to cut, at this time to pay attention to the sealing between each interface, the common leakage problem occurs in these joints.

5. Install the hanging piece to strengthen the trough body sink into the mesa, need to install the supporting hanging piece between the trough body and the mesa, will install the trough firmly, avoids the small void causes the trough body to sway. After the drainage test is finished, the filter basket is installed and the next experiment is carried out. When doing the drainage test, the sink should be filled with water and the drainage of two filter baskets and overflow holes are tested. Drainage, if found where there is water seepage phenomenon, should be immediately rework, to ensure that the future use is not hindered. After the drainage test is done around the groove, ensure that there is no problem, the sink can be closed. In the use of silicone sealing edge, to ensure that the sink and mesa connection gap evenly, can not have water seepage phenomenon.